Code 58:YZ
Description The Color Sensor (Spectrophotometer-ESP) of the printer is not working well. Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • The…
Phone: +91 99740 44629
| Email: info@rhpsolution.com
O2ML9YjB9mA2
Code 62:YZ
Description PC Interface Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Get the latest version of the firmware.
Code 66:YZ
Description Cannot print file on current paper type. The paper type has changed since the file was sent, so the file cannot be printed on the paper type currently loaded. Remedy • Resend the file to be printed on the…
Code 84:YZ
Description Back tension servo shutdown (roll feeding). Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If the problem persists, contact HP…
Code 85:YZ
Description Problem finding the Drive Roller zero. Remedy • Perform the Media Drive diagnostic test to troubleshoot the problem further 2. Paper Drive.
Code 86:YZ
Description Possible Paper Jam. Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If the problem persists, contact HP support. Open the…
Code 94.1:YZ
Description Profiling algorithm failed. Remedy • Profiling failed due to a different error (not algorithm / data processing). • Perform the Color Sensor (ESP) calibration. You must use glossy paper for this calibration. • If the System Error continues, replace…
Code 94:YZ
Description Color calibration Error. Remedy • Profiling failed due to a different error (not algorithm / data processing). • Perform the Color Sensor (ESP) calibration. You must use glossy paper for this calibration. • If the System Error continues, replace…
Code 98:YZ
Description Automatic backup print mode enabled. Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Recover the printheads.
Code 67:YZ
Description Input/Output problem through a Firewire Port. Remedy • Check that the firewire cable is correctly connected to the Printer. • Check that the Printer has the latest Firmware version. If not, update the Firmware to the latest version. •…
Code 71:19
Description Default Serial Number found in the main and backup NVM. It seems that both the PrintMech PCA and Hard Disk Drive have been replaced together. Remedy • Perform the gError 71:19 Recoveryh Service Utility 13. Error 71:19 Recovery. NOTE:…
Code 71:YZ
Description Out of memory failure. Remedy • It is recommended that you remove any unnecessary files from the Hard Disk Drive of the Formatter using the Web Server.