Code 01.0:YZ
Description Main PCA/Electronics module HCI queue does not end after 2 seconds. Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If…
Phone: +91 99740 44629
| Email: info@rhpsolution.com
O2ML9YjB9mA2
Code 44:YZ
Description Aerosol fan Fan Electrical fault, or not connected Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Aerosol…
Code 45:YZ
Description Rewinder An error with the Rewinder System has been detected Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that…
Code 47:YZ
Description Star wheel motor Star wheels motor error Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Starwheel Assembly…
Code 48:YZ
Description PPS mechanism PPS system failure Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Check that the Pen to Paper Space…
Code 51:YZ
Description Window Sensor Window Sensor failure Remedy • Check that the Window Position Sensor cable is not damaged and is correctly connected to the PrintMech PCA. • Perform the Sensors Test to troubleshoot the problem further . Page 4- 31.…
Code 52:YZ
Description Drop detector The printer has detected a problem with the Drop Detector Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. •…
Code 55:YZ
Description Line sensor Problem with the Line Sensor. The printer has detected a failure to access Line Sensor EEPROM). Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord…
Code 56:YZ
Description Drive roller analog encoder sensor Drive roller analog encoder sensor fail or calibration failed. Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the…
Code 58:YZ
Description The Line Sensor of the printer is not functioning correctly. Either the Line Sensor shutter has failed to open, there is a failure to communicate with the Line Sensor, the Line Sensor is not calibrated correctly, or the firmware…
Code 61:YZ
Description Error job The file format is incorrect and the Printer cannot process the job. Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the…
Code 62:YZ
Description PC Interface PC Interface Remedy • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • Get the latest version of the firmware.