Code 07.02:11
Description USB Cable not connected Remedy 1. Check the condition and connections of the USB cable, replace if necessary.
Phone: +91 99740 44629
| Email: info@rhpsolution.com
Error Codes
Code 07.01:11
Description DelSol3 ASIC not found or not responding Remedy 1. Check the condition and connections of the Interconnect data and power cable, replace if necessary
Code 06:YZ
Description Failure reading/writing NVM in Hard disk Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Replace the Hard Disk.
Code 03:YZ
Description Problem with Power Supply Unit Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Replace the Power Supply Unit (PSU). See…
Code 03.0:10
Description Battery of Real Time Clock ran down Remedy Replace the battery.
Code 01.0:YZ
Description Communication with Engine PCA failed Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Remove the Formatter and reinsert it again.…
Code 39.2:01
Description Roll 2 switch failed (standby or resume). Roll 2 has been unloaded. Remedy There is no corrective action. This system warning code only notifies the user that the roll has been unloaded because an unexpected error occurred with Roll…
Code 39.1:01
Description Roll 1 switch failed (standby or resume). Roll 1 has been unloaded. Remedy There is no corrective action. This system warning code only notifies the user that the roll has been unloaded because an unexpected error occurred with Roll…
Code 26:01
Description Ink supply error found during IDS diagnostic test. In the Touch Control Panel message you will see letters representing the names of the colors of the faulty supplies. Remedy 1. Reseat the faulty ink supply and repeat the Ink…
Code 24:YZ
Description Ink Setup failure Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Insert the new purgers, reconnect the power cord and power on the product. 2. Perform the Ink Delivery System…
Code 22.1:YZ
Description Left Ink Supply Station error, module 1 Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the cables between…
Code 22.0:YZ
Description Left Ink Supply Station error, module 0. Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the cables between…