Code 64:04
Description Firmware Error (USB Port). Remedy • Switch the Printer Off and wait a few minutes. Switch the Printer On again and check if the Error Code has disappeared. • If the Error Code reappears, check for a new Firmware…
Phone: +91 99740 44629
| Email: info@rhpsolution.com
O2ML9YjB9mA2
Code 71:04
Description Problem allocating Memory Remedy • Switch the Printer Off and wait a few minutes. Switch the Printer On again and check if the Error Code has disappeared. • If the Error Code reappears, check for a new Firmware release.
Code 73:04
Description Servo Error. Remedy • Switch the Printer Off and wait a few minutes. Switch the Printer On again and check if the Error Code has disappeared. • If the Error Code reappears, check for a new Firmware release. •…
Code 01:10
Description Electronics Module failure. The possible cause could be: 1. The Electronics Module is of the wrong type (a 16 MB Electronics Module will not work in a 24" Model). 2. Reading, writing or initializing the EEROM failed. 3. One…
Code 05:10
Description Formatter not detected. Formatter failure. Remedy Power OFF the Printer and reseat the Formatter.
Code 08:11
Description Front Panel cannot be detected. Remedy Reconnect the Front Panel.
Code 11:11
Description Trailing Cable badly connected. Remedy Reconnect the Trailing Cable correctly.
Code 11:13
Description Problem with setting the voltage of the Printheads. Remedy Check that the Trailing Cable is connected correctly at both ends. Replace the Trailing Cable Replace the Carriage Assembly
Code 12:11
Description A short detected in the Carriage Assembly. Remedy Remove ALL the Printheads and clean the flex contacts on the Printheads and in the Carriage Assembly. Replace ALL the Printheads. Replace the Carriage Assembly
Code 21:10
Description Service Station failure. The possible cause could be: 1. The steps counted by the Service Station motor are not consistent with the expected length of the current movement. 2. The Aerosol Fan has reached its maximum current limit. 3.…
Code 21:11
Description Service Station cannot be detected or the Service Station is badly adjusted. Remedy Reconnect the Service Station Assembly. Reposition the Service Station trip lever.
Code 22:10
Description Ink Supply Station failure. The possible cause could be: 1. Reading, writing or initializing the backup EEROM failed. 2. One of the out-of-ink sensors (located in the Ink Supply Station) is not reporting what it should during the initializing…