Code 81:01
Description Paper axis error—the copier will restart and run a diagnostic test Remedy None
Phone: +91 99740 44629
| Email: info@rhpsolution.com
O2ML9YjB9mA2
Code 81:YZ
Description Problem with paper advance. This source of error could come from an error in any of the following systems: paper motor, disk encoder, cables or main electronics. Remedy This error can occur because the product has been dropped during…
Code 45.1:YZ
Description An error with the Rewinder 1 System (Upper Rewinder) has been detected. Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Remove the paper from Roll 1. Reconnect the power cord…
Code 45.2:YZ
Description An error with the Rewinder 2 System (Lower Rewinder) has been detected . Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Remove the paper from Roll 2. Reconnect the power…
Code 47:YZ
Description Starwheels motor error Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check for any visible obstacles restricting the movement of…
Code 48:YZ
Description PPS system failure Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the Pen to Paper Space (PPS) Solenoid…
Code 51:YZ
Description Scanner Position Sensor failure Remedy 1. Check that the Scanner Position Sensor cable is not damaged and is correctly connected to the Engine PCA. 2. Perform the Sensors Test to troubleshoot the problem further. See Sensors Test. 3. Replace…
Code 52:10
Description The product has detected a failure in the Drop Detector. Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that…
Code 55:YZ
Description Problem with the Line Sensor. The product has detected a failure to access the Line Sensor EEPROM. Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and…
Code 56:YZ
Description Drive roller analog encoder homing (also known as “zero search”) failed. Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Perform…
Code 59.1:09
Description Two electrical parts have been replaced at the same time. Remedy Replace one part at a time, and restart the product before replacing another.
Code 60.1:YZ, 60.2:YZ
Description Initialization error Remedy 1. Switch the power off from the back of the product, wait two minutes, then switch it back on again. 2. Check the power cord; try connecting it to another power socket. 3. Check that the…