Code 21:YZ
Description Failure moving Service Station Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Check the Primer Tubes. Reconnect the power cord and power on the product. 2. Make sure that the…
Phone: +91 99740 44629
| Email: info@rhpsolution.com
O2ML9YjB9mA2
Code 22.0:YZ
Description Left Ink Supply Station error, module 0. Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the cables between…
Code 22.1:YZ
Description Left Ink Supply Station error, module 1 Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the cables between…
Code 24:YZ
Description Ink Setup failure Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Insert the new purgers, reconnect the power cord and power on the product. 2. Perform the Ink Delivery System…
Code 26:01
Description Ink supply error found during IDS diagnostic test. In the Touch Control Panel message you will see letters representing the names of the colors of the faulty supplies. Remedy 1. Reseat the faulty ink supply and repeat the Ink…
Code 39.1:01
Description Roll 1 switch failed (standby or resume). Roll 1 has been unloaded. Remedy There is no corrective action. This system warning code only notifies the user that the roll has been unloaded because an unexpected error occurred with Roll…
Code 39.2:01
Description Roll 2 switch failed (standby or resume). Roll 2 has been unloaded. Remedy There is no corrective action. This system warning code only notifies the user that the roll has been unloaded because an unexpected error occurred with Roll…
Code 41:YZ
Description Electrical fault or current limit in Media-Axis Motor Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check for any visible…
Code 42:YZ
Description Electrical problem (fault, current limit, overheating) in Scan-Axis Motor Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check for any…
Code 71:04
Description Out of memory. The total memory available in the product depends on its configuration. It is reported as HPGL/ 2 memory or PS/PDF memory. If the amount of memory that the product needs to process the file is more…
Code 72.02:09
Description Generic firmware Error Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the product has the latest firmware version.…
Code 72.02:YZ
Description A service calibration should be performed. Remedy To find out which service calibration to perform, print the calibration status. At the Touch Control Panel, select the Internal Prints icon, then Service information > Print calibration status. Perform whichever calibration…