Error Codes

Code 56:10

Description Drive Roller Encoder Sensor error. Remedy Replace the Drive Roller Encoder Sensor If the problem persists, replace the Encoder Disk Assembly.

Code 05:09

Description Formatter installed instead of HP-GL/2 Accessory Card. Remedy Power OFF the Printer and remove the Formatter and install the HPGL/2 Accessory Card

Code 02:13

Description Carriage failure. The possible cause could be: 1.One of the ASIC’s in the Carriage is reporting that it is too hot. Remedy Switch the Printer Off and wait a few minutes. Switch the Printer On again and check if…

Code 02:10

Description Carriage failure. The possible cause could be: 1. The Carriage PCA is not compatible with the rest of the Printer. 2. The Carriage ASIC has problems initializing. 3. The +2.5V reference voltage generated in the Carriage PCA is out…

Code 01:13

Description Electronics Module failure. The possible cause could be: 1. One of the ASIC’s in the Electronics Module is reporting that it is too hot. 2. The interruptions from the Scan-Axis servo or from the Paper-Axis servo are not coming…

Code 01:12

Description The EEROM is not configured correctly (the product number may Remedy Configure the EEROM correctly using the EEROM setup utility