Error Codes

Code 45.2:YZ

Description An error with the Rewinder 2 System (Lower Rewinder) has been detected . Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Remove the paper from Roll 2. Reconnect the power…

Code 45.1:YZ

Description An error with the Rewinder 1 System (Upper Rewinder) has been detected. Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Remove the paper from Roll 1. Reconnect the power cord…

Code 24:YZ

Description Ink Setup failure Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Insert the new purgers, reconnect the power cord and power on the product. 2. Perform the Ink Delivery System…

Code 22.1:YZ

Description Left Ink Supply Station error, module 1 Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the cables between…

Code 22.0:YZ

Description Left Ink Supply Station error, module 0. Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the cables between…

Code 21:YZ

Description Failure moving Service Station Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Check the Primer Tubes. Reconnect the power cord and power on the product. 2. Make sure that the…

Code 21.2:YZ

Description Failure testing the length of the Service Station path Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Check the Primer Tubes. Reconnect the power cord and power on the product.…

Code 11:YZ

Description Trailing Cable does not seem to be detected Remedy 1. Switch the power off from the back of the product and disconnect the power cord. Reconnect the power cord and power on the product. 2. Check that the Trailing…

Code 09:01

Description Media jam in Scanner Remedy 1. Open the CIS to solve the media jam and close it again. 2. If no paper is seen, run Scanner Motor Diagnostic, refer to the Users Guide for further details.